Triangle Area Calculator — (Base × Height)/2 with Pitfalls
Triangle area A = (base × height)/2. Height must be perpendicular to the chosen base. Worked examples and obtuse-triangle notes — free geometry tool.
Inputs
Area
—
Where this formula comes from
Any triangle can be viewed as half of a parallelogram with the same base and height. That yields A = (base × height) / 2 when height is perpendicular to the chosen base.
For obtuse triangles the altitude may fall outside the segment, but the perpendicular distance to the base line is still the correct height.
If you only know three sides, use Heron’s formula on a dedicated tool; this page is the base-height path.
Common mistakes
- Using a slanted side as heightHeight must be perpendicular to the base you chose.
- Mixing side unitsConvert first; area uses square units of the inputs.
- Expecting SSS from this modeThree-side problems need Heron or trigonometry, not this form alone.
How to use this calculator
This mode uses base and perpendicular height: area = ½ × base × height. The height must be measured at right angles to the base you chose, not along a slanted side.
Any side can serve as base if you use the matching altitude to that side. Switching bases without switching heights is a common exam error that silently doubles or halves the area.
For three side lengths only, use Heron’s formula or another SSS method — this page is the base-height case. Right triangles can also use the two legs as base and height when the right angle sits between them.
Keep linear units consistent; area comes out in square units. Sketch the altitude if the triangle is obtuse — the foot may fall outside the segment, but the perpendicular distance is still the height in the formula.
Coordinate geometry offers another check: with vertices known, the shoelace formula should match ½bh when height is measured consistently. Disagreement usually means the altitude was taken to the wrong side.
Very skinny triangles are numerically sensitive: tiny height errors create large relative area errors. Prefer more precise height measurements when the triangle is needle-shaped.
Surveying and CAD tools may give you two sides and an included angle (SAS). Area is then ½ab sin(C), which is a different input set than base-and-height. Convert SAS to an altitude first if you insist on using this page, or use a SAS-capable tool directly.
Dropping an altitude outside the triangle in the obtuse case still yields a positive length used in ½bh. Sketching prevents you from rejecting a valid height just because the foot is not between the base endpoints.
Frequently asked questions
- What triangle area formula is used?
- For base and height: A = (base × height) / 2. Height must be perpendicular to the chosen base.
- Do I need all three sides?
- Not for this mode—base and perpendicular height are enough. Heron’s formula needs three sides (use another tool if listed).
- Can the height sit outside the triangle?
- For obtuse triangles the altitude may fall outside; the formula still uses perpendicular distance to the base line.
- What units does area use?
- Square units of the inputs (cm → cm²). Keep base and height in the same unit.